1
Archived Support / Run-time error
« on: October 22, 2006, 02:10:32 PM »
That was quick, thanks.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Archived Support / Run-time error
« on: October 22, 2006, 08:36:05 AM »
Run-time error '-2147417848 (80010108)':
Automation error
The object invoked has disconnect from its clients.
I receive this error when I attempt to Interpolate a route, leaving all other options as they were.
TopoFusion version 2.97
GPX file at http://www.kg6esx.net/grand.gpx
Automation error
The object invoked has disconnect from its clients.
I receive this error when I attempt to Interpolate a route, leaving all other options as they were.
TopoFusion version 2.97
GPX file at http://www.kg6esx.net/grand.gpx
3
Archived Support / How close must parallel tracks be
« on: June 16, 2004, 07:13:10 PM »
Well, since the dataset I would perform this on is the same that reproduces the access violation reported yesterday I'll wait to see what becomes of that.
When I did try playing with the strength sliders (only to 99) there was:
no difference
access violation
'hang'
BTW: The dataset is winging its way to you as I type this.
When I did try playing with the strength sliders (only to 99) there was:
no difference
access violation
'hang'
BTW: The dataset is winging its way to you as I type this.
4
Archived Support / How close must parallel tracks be
« on: June 15, 2004, 05:49:35 PM »
For them to be reconized as parallel tracks?
I have a track in which the same trail is transversed three times.
Making a network joined two of the tracks. I would like the third to be included, at least until it does branch off.
How would, or should, I move a segment of track?
I have a track in which the same trail is transversed three times.
Making a network joined two of the tracks. I would like the third to be included, at least until it does branch off.
How would, or should, I move a segment of track?
Pages: [1]