TopoFusion support forums

TopoFusion Support => TopoFusion Pro => Topic started by: colprit on June 29, 2008, 03:22:25 PM

Title: Elevation Server Error
Post by: colprit on June 29, 2008, 03:22:25 PM

I recently switched to a new computer running Vista. I'm getting an error message concerning the elevation server.

When I select "Correct Elevations" in the Run Analysis, an error message comes up saying "Could not connect to the elevation server, it may be busy, try again later".

Any ideas on this?

Title: Elevation Server Error
Post by: ScottMorris on June 29, 2008, 03:25:18 PM

Yup - Nasa server is not currently serving 3D data.



There's a topic in the announcements forum about it.

Should be back Jul 1.

Title: Elevation Server Error
Post by: colprit on June 29, 2008, 03:30:12 PM

Thanks. Since the server must have gone down during my transfer to Vista, I wasn't sure if it was an OS problem.

Forgot to mention: When I do select "correct elevations", the tile switches to Land Sat, which is annoying. Can this be fixed?

Title: Elevation Server Error
Post by: ScottMorris on June 29, 2008, 03:44:00 PM

Hmm, it's supposed to switch back, but it probably errors out first.

Wait until the server is back, then it will just change briefly, and change back.

It's not a bad idea to change back even with an error, though.  Thanks.

Title: Elevation Server Error
Post by: ScottMorris on July 01, 2008, 06:30:06 PM

Back up.